C5500n User's Guide

Chapter 9 Printer Settings (Menu Settings)
Network Menu

Note: Factory default settings are shown in bold.

ItemActionExplanation
TCP/IPENABLE
DISABLE
Enables or disables this network protocol.
NETBEUIENABLE
DISABLE
Enables or disables this network protocol.
IP ADDRESS
SET
AUTO
MANUAL
Change this to Manual to specify the IP address through the front panel (see next entry). Required for non-DHCP networks.
IP ADDRESSxxx.xxx.xxx.xxx
Default =
198.168.100.100
Current assigned IP address. To change:
  • Press ENTER.
  • Use +/- keys to increment first octet.
  • Press ENTER to move on to the next octet.
  • Use +/- keys to increment second octet.
  • Press ENTER to move on to the next octet.
  • Use +/- keys to increment third octet.
  • Press ENTER to move on to the last octet.
  • Use +/- keys to increment 1st octet.
  • Press ENTER to register the new address.
SUBNET MASKxxx.xxx.xxx.xxx
Default =
255.255.255.000
Current assigned subnet mask. To change, proceed as above.
GATEWAY
ADDRESS
xxx.xxx.xxx.xxx
Default =
192.168.100.254
Current assigned gateway address. To change, proceed as above.
INITIALIZE
NIC?
[EXECUTE]Initializes the network card.
WEB/IPPENABLE
DISABLE
Enables or disables Web config. facility and Internet Printing Protocol. This item will not appear in the menu if TCP/IP is set to DISABLE.
TELNETENABLE
DISABLE
Enables or disables Telnet config. facility.
This item will not appear in the menu if TCP/IP is set to DISABLE.
FTPENABLE
DISABLE
Enables or disables communication via FTP.
This item will not appear in the menu if TCP/IP is set to DISABLE.
SNMPENABLE
DISABLE
Enables or disables SNMP protocol.
LANNORMAL
SMALL
Normal = Global network
Small = Local network
HUB LINK
SETTING
AUTO NEGOTIATE
100BASE-TX FUL
100BASE-TX HALF
10BASE-T FULL
10BASE-T HALF
Sets full or half duplex for communication via a network hub.